• Mould and mildew from concrete floors, walls and roof tiles
• Mould and mildew from bathrooms, kitchens, laundries
• Yellow & green stain from bricks
Mould Action Pre-Paint Treatment is a very effective mould and mildew killer. It contains low toxicity ingredients with high antimicrobic activity. It is non-corrosive and does not contain dangerous formaldehyde or ammonia. Mould Action is biodegradable.
Unlike ordinary fungistats which only prevent the growth of fungus, Mould Action actually eliminates bacteria and fungi which occur on all types of surfaces. It is recommended as a surface sterilant for pre-decoration of masonry, brick, wood, plaster, etc.
Apply Mould Action by brush, spray or wiping over the entire area to be painted, not just the visible growth areas. Fungal spores are minute and may be concealed in an area that does not look contaminated. Allow Mould Action to remain on the surface for 24 hours for complete penetration of the pores of the surface. Then rinse, wash or brush off all dead bacteria residue. Let dry thoroughly and paint.
NOTE: In very severe mould conditions it is advisable to apply a second coat of Mould Action and allow it to dry completely prior to overpainting, but be sure to paint before the next rain.
To prevent further mould growth on newly painted areas, add a few drops of VC175 Tropical Mould Killer into the paint.
5 to 20 square metres depending on porosity of the surface and the degree of contamination.
Mould Action 750ml Spray Bottle, 1L, 4L, 20L