The Flip Lock Nut allows you to create neat, streamlined wire runs between existing metal posts. Used with M6 threaded fittings such as swage stud terminals for 3.2mm and 4.0mm wire.
*Suitable for Right Hand Thread (RHT) M6 terminals only.
The Flip Lock Nut allows you to create neat, streamlined wire runs between existing metal posts. There is no design on the market like it. It eliminates the requirement for installing rivet nuts and rivet nut tools. All you require is a swage stud terminal RHT fitting, and then the same LHT fittings at the opposite end of the run. Used with M6 threaded fittings such as swage stud terminals for 3.2mm wire.
Please note: this is just the RHT Flip Lock Nut. The complete Flip Lock System (purchased in kit form here) consists of the following components:
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
