Prevent your wire rope from chafing and being damaged on your intermediary posts with black nylon grommets suitable for 3.2mm to 4.0mm wire. They're split so can be installed after your wire and fittings are installed. Post hole 8.0mm drill size required.
Black nylon split grommets suitable for 3.2mm to 4.0mm wire. The split grommet allows for installation after the wire balustrade has been installed. Simply use a pen to open up the grommet split, slot over the wire and press into the post hole.
The grommet diameter is 8.0mm, so a 8.0mm metric drill size is required for the post hole.
Also available in grey. Angled grommets for stairs and ramps also available.
Perfect for use in wire balustrade applications to protect the wire when threaded through posts, especially metal round tube, square and RHS. Flat bar is typically too thin to use the grommets.
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
