A staff favourite, the Black PVD coated Flip Lock system allows you to create neat, streamlined wire runs between existing metal posts. No more rivet nuts needed! Not suitable for use in beachfront properties or areas subjected to salt spray.
Black Stainless
Straight & Angled Sections
The Flip Lock Nut combined with a Swage Stud Terminal allows you to create neat, streamlined wire runs between existing metal posts. There is no design on the market like it. It eliminates the requirement for installing rivet nuts and rivet nut tools. All you require is a Flip Lock Nut RHT, swage stud terminal RHT, and then the same LHT fittings at the opposite end of the run. Used with M6 threaded fittings such as swage stud terminals for 3.2mm wire.
All in blackened stainless steel , these fittings require hydraulic swaging/crimping with an entry level 5T light duty hydraulic swaging tool (see notes below on the use of tools and hardened dies) or via a 30T Hydraulic Swaging Press.
Factory Hydraulic Swaging is recommended for this kit - please enquire for availability and pricing.
The complete Flip Lock System consists of the following components:
Please note the use of hardened dies, heavy duty hydraulic swaging tools (including the 8T and 12T hydraulic tools) and other swaging procedures are not recommended as it will impact the finish of the final product and are not covered under standard product warranty.
DO NOT USE in saline/salt prone environments especially areas subjected to salt spray from the coast. Any use within this environment will corrode the finish which cannot be rectified and will void any warranty. If your project is subject to this kind of environment, please contact us for clarification and alternative options.
Avoid using harsh cleaners, chemicals and abrasives on and around the BlackLine wire and fittings. The blackened surface of the stainless steel may be stripped off, discoloured or degraded.
AVOID acid based cleaners such as oxalic acid (deck cleaner), vinegar or InnoShine B570 / InnoGel B450.
USE a mild, pH neutral cleaner, such as orange citrus or mild detergent with a non-abrasive cloth.
| Product Material | Blackened Stainless Steel |
|---|---|
| Swaging System | Hydraulic Swaging |
| Post Fixing Material | Metal |
| Section Type | Straight Sections, Angled Sections (eg. Stairs / Ramps) |
| Wire Rope Diameter | 3.2mm |
| Product Specifications | Flip Lock Nut
Swage Stud Terminal
*D1/D are incorrect in the diagram. |
| Stock Availability | In Stock |
| Bulky item | No |
Known Incompatible Products
DO NOT USE in saline/salt prone environments especially areas subjected to salt spray from the coast. Any use within this environment will corrode the finish which cannot be rectified and will void any warranty. If your project is subject to this kind of environment, please contact us for clarification and alternative options.
Avoid using harsh cleaners, chemicals and abrasives on and around the BlackLine wire and fittings. The blackened surface of the stainless steel may be stripped off, discoloured or degraded.
AVOID acid based cleaners such as oxalic acid (deck cleaner), vinegar or InnoShine B570 / InnoGel B450.
USE a mild, pH neutral cleaner, such as orange citrus or mild detergent with a non-abrasive cloth.
