A neat and slimline stainless steel balustrade kit for 10 metre + sections of wire spanning between timber posts. Comprises two Swage Stud Bottlescrews and Threaded Timber Inserts. Hydraulic swaging required.
This stainless steel wire rope balustrade kit is very slimline, neat and aesthetically pleasing. The dual bottlescrews help provide additional tension capability especially for 10 metre or longer runs. This kit is for those who are looking to minimise balustrade wire fitting bulk.
Instructions
Pre-drill your 9.5mm post holes for the threaded timber inserts.
Drive the threaded timber inserts into the post with a 6mm hex drive bit.
Insert the wire rope into the swage stud bottlescrew swage end and crimp using a hydraulic swaging tool. Thread the wire through the intermediate posts. Then do the same for the other swage stud bottlescrew.
Thread the swage stud bottlescrew thread into the threaded timber insert. Repeat for the other swage stud bottlescrew end. Thread with hands first and tension the swage stud bottlescrew with a bottlescrew spanner.
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
For technical requirements where you are unsure what products are and are not compatible please Contact Us.
Please note these are general Compatibilities/Incompatibilities, we cannot provide advice as to whether these components will meet the technical/structural requirements of your project. For this type of information you will need a builder, engineer or other qualified professional to assess your site and needs.
